 |
Spars, Rigging, and Hardware for SailboatsRig-Rite, Inc. |
Z10 Spreaders & Components |
|
|
|
|
|
Spars, Rigging, and Hardware for SailboatsRig-Rite, Inc. |
Z10 Spreaders & Components |
|
|
|
|
| Z-Spar Z10 Spreader Section Outside Measurements (Untapered): 44mm x 10mm (1 3/4" x 3/8") Inside Measurements: 30mm x 4.5mm (1 1/8" x 3/16") Wall thickness: 1.5mm Weight/M.: 0.4kg. - Weight/ft.: 0.27 lbs. |
|
|
|
|
|
Z10 Tapered Spreader Assembly x 26": Z-10AT-26: Z10 Tapered Spreader Assembly x 39": Z-10AT-39: Z10 Tapered Spreader Assembly - Custom Length: Z-10AT-____: Standard Z10 Spreader Assembly is anodized and Tapered and includes a Z-3112 Spreader Tip. To order specify maximum tube length, and sweepback angle (if any).
|
|
|
Z10 Tapered Spreader - Tube only, Tapered & Drilled: Z-10TT-____: For replacement purposes when using original end fittings, Z10 Spreader Tubes are available Tapered and drilled for Z-3112 Spreader Tip, and with inboard angles cut. To order specify maximum tube length, and sweepback angle (if any). Clear anodized finish is standard.
|
|
|
Z10 Spreader Section, Clear Anodized: Z-10CA-____: Z10 Spreader Section is available clear anodized, but without taper or drilling at lengths up to 12'. To order specify maximum length.
|
|
|
|
|
|
Spreader Tip for Z10 Spreader: Z-3112:
Cast aluminum Spreader Tip for Z10 Spreader captures shroud when inserted into spreader. Attaches with one screw.
|
|
|
Spreader Base for Z10 Spreader: Z-1036:
Cast aluminum spreader base for Z10 Spreader. Accommodates a variety of spreader angles by adjusting position on the mast. Base is (maximum) 2 1/8" (54mm) long x 1 1/2" (38mm) high, and attaches to Mast with (4) 3/16" (5mm) rivets. As used on Z145 and other Mast Sections. This item is no longer available and is shown here for identification only. 3182
|
|
| Spreader Base for Z105, Z125 or Z145 Mast & Z10 Spreaders: Z-1250X-2: | |
|
Wrap-around Stainless Steel Spreader Base for Z105, Z125 and Z145 Mast Sections and Z10 Spreaders.
Formed SS base holds both spreaders and accommodates a variety of
spreader angles. Spreaders are attached with 5mm (3/16") bolts (2 each),
unit attaches to Mast with (4) 5mm (3/16") screws or rivets. 3183
|
|
|
Spreader Base for Z145 Mast & Z10 Spreaders: Z-145SB-2:
Wrap-around Spreader Base for Z145 Mast Section and Z10 Spreaders. Cast aluminum base holds both spreaders and accommodates a variety of spreader angles. Spreaders are attached with 6mm (1/4") bolts (2 each), unit attaches to Mast with (6) 5mm (3/16") screws or rivets. |
|
~ Back to Z-Spar Spreader Page ~
~ Home ~
